Any question ? Find the answer

Could you send me the manual worker of the tractor B7001 ?

The tractor B7001 which you buy is a second-hand tractor imported by parallel network, without the agreement of KUBOTA Europe, and that it was never marketed under this designation in France by our Company, or approved. Therefore, it isn’t possible to us to give you satisfaction.

Do you build power generating units and pumps ?

Engine division doesn’t market any more this kind of products. You can all the same contact your dealer for second-hand equipment.

Do you supply in spare parts for the occasions tractors imported by Asia ?

We insure the supply of spare parts for tractors duly approved by KUBOTA Europe, and not for those imported by a parallel market. Among others reasons, most of these second-hand models, used in some countries of Asia, were not approved by KUBOTA Europe under their designation, and spare parts are not always common to the models distributed officially by our company. So, be watchful in your project of purchase, because we receive regularly customers’ complaints who bought this type of material, and which are out of order today.

Does KUBOTA EUROPE supply the spare parts ?

KUBOTA Europe supplies a big quantity of spare parts more than 100 000 available references. 96% of parts can be obtained at all time within 24 hours.

Does the cleaning up of a machine TP have it to be done regularly ?

We strongly advise to clean up the hydraulic system in the event of damage of components (pump, engine…) in order to stop the contaminations which could have circulated in hydraulics of the machine. However, we have more and more customers who clean up their machines on a purely preventive basis, for example at the time of usual maintenance. The lifetime of the components is some increased and the breakdowns due to the contaminations (seizing of valves) are appreciably reduced. It is enough to make heat the machine (oil with 50°C), to connect the filter of cleaning up on the auxiliary line, to press on the pedal and to let the diesel engine outside to 1500 rpm approximately. 15 minutes are sufficient for an operation. The quality of the filter must be as follows : 5 microns ; Beta : 200 ; nominal capacity 100 to 150 litres/minutes (according to your hydraulic machine most important.)

Have you got spare parts for diesel generator typified AC KUBOTA 1100 Q ?

This model of generator is a model not approved by Kubota Europe. Please , distrust the parallel market. You can contact us or contact your dealer if you doubt. We have no documentations corresponding to these models.

How to replace a manufacturer plaque of a Kubota’s machine TP in case of loss ?

You have to send an order to the Spare Parts’ Department. It’s necessary to mention the type of the machine, its serial numbers and the year of manufacture.

I am about to acquire a power tiller LP360, year 75. I wanted to know if in spite of the reputation of robustness, spare parts were still available for this model ?

We are pleased that this power tiller give you satisfaction from so long time. Now it is very difficult to find spare parts for this model, its marketing being stopped for a long time. Please , inquire all the same with your dealer.

I have acquire B8200 Kubota’s tractor. I have to change the engine. Which type of engine can I obtain ? Can I put a more powerful engine ?

No, we can’t mechanize again a Kubota tractor by another type of engine without calling into question the engine application.

I have got a brush-cutter F400 and the thrower is very damaged. In spite of my researches I didn’t find spare parts. Whom should I address ?

This model is rather old. For more information, you can contact the Spare part service of Kubota Europe or your dealer.

I have just purchased a new tractor B1610D. On this machine, fires stop do not work, although is equipped and indicated it on the note. Is it an anomaly or an option ? Is it possible to equip it with a bar of harness with holes ? Kubota markets this kind of accessory ?

Fires stop, side mirror and hooking on are optional on the B1610 because this tractor is a new model approved in France and that the French rule does not require these accessories from series. It is possible to equip it with a bar of harness with holes, accessory marketed by Kubota Europe.

I’m looking for a second-hand equipment… Have you got a seconhand network, advertisements on line ?

Kubota Europe haven’t got a secondhand network and don’t pass advertisements on line. On the other hand you can contact your dealer who will not fail to inform you.

Is it possible to obtain manual workers of Kubota’s old models ?

To get manual workers of old models, don’t hesitate to contact your dealer.

Is there the typical mulching blade on the lawn mowers Kubota ?

It is possible to install a mulching kit on the lawn mowers of the series W consisted of 3 models : W521TC, W521HTC and W621HTC.

We make build on a ground of 2000 m² that it would be necessary to plough. Can we put a small plough behind the lawn mower ?

No, it is not possible to put a plough behind the lawn mower.

What type of grease can we use ?

We advise grease containing Lithium or EP. For the first 50 hours, we recommend ’ anti-seize’ WEICON lubricant. On the other hand, PROHIBITED : Grease which contain calcium (Ca).

Which type of lubricant must we put for the various parts of a mini-excavator ?

For diesel engine, we advice you to use a diesel engine oil 15W40. For the hydraulic system you can use hydraulic traditional ISO 46 oil. For travel gearbox, swivel gearbox, track rollers and idle wheels, the 80W90 oil is OK. Please consult the user’ manual for the service intervals and for the details according to particular climates. “Multifunction” oil are forbidden.